About 3 Hours Intumescent Pipe Wrap
The wrap is fitted into the hole, leaving a 10mm gap back from the wall face for pointing with sand and cement or slab coating.
The wraps will seal the void around PVC pipes and cables and will cool steel pipes when attacked by fire.
A label is supplied to adhere to treated pipes or cables for identification to the relevant authorities.
The wrap provides up to 3 hours protection.
It will crush melting PVC or UPVC pipes/cables in a fire, filling the gap to prevent fire and smoke spreading.
Provides effective insulation for metal pipes, absorbing the heat from the pipe to prevent it from spreading through the structure.
25mm wraps will provide 1 hour protection, 30mm wraps will provide 3 hours protection, 50mm and 100mm wraps will provide 3-4 hours
Available in a continuous 10m roll which can be cut to size to fit services of practically any diameter.
Range also includes a repair kit which can be used to fill small openings around existing services, offering up to 2 hours fire resistance.
Materials will not degrade, lasting a lifetime in-situ.
Application Instructions
Standard Wrap:
- Wrap around the pipe or cable at the point where it passes through the wall, floor or ceiling.
- The attached adhesive strip is then used to fix both ends of the wrap together.
- Push the wrap into the hole around the service, leaving 10mm protruding from the wall face which can be pointed around as required.
Continuous Wrap:
Wrap comes in a 10m roll and must be cut to size and applied in layers.
The 30mm wrap is for pipes from 15mm-200mm in diameter and should be applied as follows:
- i. For pipes 15mm-65mm in diameter, adhere one layer to the pipe
- ii. For pipes 75mm-127mm in diameter, adhere two layers to the pipe
- iii. For pipes 160mm-200mm in diameter, adhere three layers to the pipe
The 50mm wrap is for pipes from 40mm-400mm in diameter and should be applied as follows:
- i. For pipes 40mm-115mm in diameter, adhere one layer to the pipe
- ii. For pipes 127mm-215mm in diameter, adhere two layers to the pipe
- iii. For pipes 250mm-400mm in diameter, adhere three layers to the pipe
The wrap has an adhesive strip on one side, which is easily adhered to the pipe once cut to size.
Review this Product